King gates ROLLS Instrucciones Para La Instalación página 30

8
9
10
2
12
13
- 28 - ENGLISH
1
C
2
D
1
3
B
2
E
1
F
3.2.3 - FITTING THE GEARMOTOR TO THE
GUIDE
Fit the ROLLS gearmotor output shaft to the guide head [A] and
secure using 4 M6.3x38 screws [G]; (fig. 14).
D
14
3.2.4 - MOUNTING THE GEARMOTOR TO THE
CEILING
1. On the basis of distances A, B and C in figures 2 and 3, trace
the two fixing points of the front guide bracket at the centre
of the door. On the basis of the type of material, the front
bracket can be fixed with rivets, plugs or screws (fig. 15). If
11
distances A, B and C (fig. 2 and 3) are sufficient, the bracket
can be fixed directly onto the ceiling.
15
2. After drilling the holes in the relative points, leaving the
gearmotor on the ground, lift the guide from the front section
and secure using two screws, plugs or rivets, according to the
installation surface.
3. Secure the brackets [H] using the screws [I] and nuts [L],
A
selecting the hole most suited to ensure distance B, as shown
in fig. 16.
16
4. Using a ladder, lift the gearmotor until the brackets are
touching the ceiling. Trace the drilling points and then return
the gearmotor to the ground.
1
A
2
G
1
L
I
2
B
H
0÷400 mm