Publicidad
Idiomas disponibles
Idiomas disponibles
3.4 - ELECTRICAL CONNECTIONS
1. Open the cover by removing the cover plastic [1] and
unscrewing the screw [2] (fig.24). Slide the cover out (fig. 25).
24
25
2. Pass the power cable through hole A and the accessory cables
through hole B (fig. 26).
26
B
A
3. The cables must then be connected (fig. 27).
27
- 30 - ENGLISH
1
2
4. Refer to fig. 28 and the connection descriptions in table 5
when making the connections: if using the flashing light
aerial, remove the wire clip (connected to terminal 14 as
standard) and connect the RG58 shielded cable.
5. Once you have connected up all the cables, secure them using
cable clips.
m
ATTENTION: to avoid the risk of the power cable
coming off, it is necessary to apply a clamp on the inside of
the motor and one on the outside.
6. To close the cover, reinsert it in place, tighten the screw and
replace the plastic cover.
3.5 - DESCRIPTION OF THE ELECTRICAL
CONNECTIONS
The following is a brief description of the electrical connections
(table 5); for further information, please read section 10 ("Devices
connectable to the control unit").
14
13
Step
Auto
Check
Func
Flash
S2 Photo
Phototest
Start
Stop
0 V
24 V
S1 Edge
24 V
L
N
28
SET
RAD
STA
SIC
STP
ERR
F 10AL
F 3.15AL
Publicidad
