Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 - PROGRAMMING THE BUTTON LINKED
TO THE "AUX" OUTPUT
This procedure allows you to program the radio control connected
to the "AUX" output (output not active at the factory).
To use this function, the "AUX" output must be set to courtesy
light.
1. PRESS THE RADIO BUTTON FOR 1 SECOND: The red "radio"
LED turns on in the fixed mode
2. PRESS THE START BUTTON FOR 1 SECOND: The red "radio"
LED remains lit in fixed mode and the red "error" LED turns on
in fixed mode
3. PRESS THE DESIRED BUTTON OF ALL THE TRANSMITTERS TO
BE PROGRAMMED: The red "radio" LED flashes and the red
"error" LED turns on in fixed mode
4. PRESS THE RADIO BUTTON UNTIL THE RADIO LED TURNS OFF
OR WAIT 20 SECONDS TO EXIT THE PROCEDURE: The red
"radio" LED and the red "error" LED turn off
5.3 - PROGRAMMING OF THE BUTTON
LINKED TO THE ON-BOARD COURTESY LIGHT
This procedure allows for programming the button of the radio
control linked to the on-board led courtesy light.
1. PRESS THE RADIO BUTTON FOR 1 SECOND: The red "radio"
LED turns on in the fixed mode
2. PRESS THE SET BUTTON FOR 1 SECOND: The red "radio" LED
remains lit and the yellow "set" LED turns on in fixed mode
3. PRESS THE DESIRED BUTTON OF ALL THE TRANSMITTERS
TO BE PROGRAMMED: The red "radio" LED flashes and the
yellow "set" LED remains lit in fixed mode
4. PRESS THE RADIO BUTTON UNTIL THE RADIO LED TURNS OFF
OR WAIT 20 SECONDS TO EXIT THE PROCEDURE: The red
"radio" LED and the yellow "set" LED turn off
5.4 - DELETING ALL MEMORISED
TRANSMITTERS
This operation deletes all memorized transmitters from the
memory.
1. PRESS THE RADIO BUTTON FOR 4 SECONDS AND RELEASE IT
WHEN THE RADIO LED STARTS FLASHING: The red "radio"
LED flashes (if not, refer to Paragraph 15)
2. PRESS THE RADIO BUTTON FOR 1 SECOND: The red "radio"
LED flashes quickly to signal the deletion in progress
3. WAIT FOR THE END OF THE PROCEDURE: The red "radio" LED
turns off
5.5 - DELETING A SINGLE TRANSMITTER
This operation deletes a single transmitter from the memory.
1. PRESS THE RADIO BUTTON FOR 4 SECONDS AND RELEASE IT
WHEN THE RADIO LED STARTS FLASHING: The red "radio"
LED flashes (if not, refer to Paragraph 15)
2. PRESS THE SET BUTTON FOR 1 SECOND: The red "radio" LED
flashes and the yellow "set" LED turns on in fixed mode
3. PRESS A BUTTON ON THE TRANSMITTER YOU WISH TO
CANCEL: The red "radio" LED flashes and the yellow "set"
LED flashes
4. WAIT 5 SECONDS TO EXIT THE PROCEDURE: The red "radio"
LED and the red "error" LED turn off
5.6 - REMOTE TRANSMITTER
PROGRAMMING
This procedure enables you to program a new transmitter without
accessing the control unit, but keeping close to it.
To run the procedure you will require a previously programmed
transmitter, to inherite its functions.
1. ON A PREVIOUSLY PROGRAMMED TRANSMITTER, HOLD
DOWN BUTTONS 1 AND 2 TOGETHER FOR 4 SECONDS
2. ON THE TRANSMITTER YOU WANT TO PROGRAM, HOLD
DOWN BUTTONS 1 AND 2 TOGETHER FOR 4 SECONDS
ENGLISH - 33 -
Publicidad
