Publicidad
Idiomas disponibles
Idiomas disponibles
1. GENERAL WARNINGS FOR THE INSTALLER
RISK OF ELECTRIC SHOCK, EXPLOSION OR ELECTRIC ARC
• Shut down all equipment, including connected devices, before removing any lid or door, or before
installing/uninstalling accessories, hardware, cables or wires, except for the conditions specified in the user
manual for this equipment.
• To verify that the system is out of voltage, always use a correctly calibrated voltmeter at the rated voltage.
• Before returning the live unit, reassemble and secure all covers, hardware and cables. Make sure that the
cable inlet is sealed to prevent insect entry and moisture formation.
• Use this equipment and all products connected only to the specified voltage.
• Where there is a risk of damage to personnel and/or equipment, use the necessary safety interlocks.
• Do not use this equipment for safety critical functions.
• Do not disassemble, repair or modify the equipment.
• This product is not suitable for installation in applications where it can come into contact with explosive or
flammable atmosphere.
Failure to comply with these instructions will result in death or serious injury.
• Do not expose the equipment to liquid substances.
• Do not exceed the temperature and humidity ranges specified in the technical data and leave the slit area
ventilated.
• Connect only compatible accessories to the device as reported in the user manual.
• Use only cables of appropriate cross-section as indicated in the section "GUIDELINES FOR ELECTRICAL
CONNECTIONS". Tighten the connections in accordance with the technical specifications for the closing
torques and verify the correct wiring.
• Electrical cables must not come into contact with parts that can become hot and with parts of the auto-
mation in motion.
Failure to comply with these instructions will result in death or serious injury.
• Do not use with loads other than those indicated in the technical data.
• Do not exceed the maximum allowable current; in case of higher loads use a contactor of suitable power.
• Power lines and output connections shall be properly connected and protected by fuses when required by
national and local regulatory requirements.
Failure to comply with these instructions may result in death, serious injury or damage to
equipment.
6-1622467M - rev. 1 - 07/03/2024
DANGER
DANGER
RISK OF ELECTRIC SHOCK AND/OR FIRE
WARNING
RISK OF OVERHEATING AND/OR FIRE
Translated from the original language - English - 3
Publicidad
