Function of Soft Stop
It allows to adjust the deceleration ramp in case of request of stop by user command or in case of intervention of the photocell
inputs (PH1 and PH2). This parameter DOES NOT modify the deceleration ramp in case of intervention of the EDGE (safety coast)
and STOP input.
PARAMETER
Sft
Modbus Address
Address attribute to the control unit to establish a communication according to MODBUS protocol on the UART port available.
PARAMETER
MbAdr
Reset Default Values (RESET)
It performs a reset of the control unit and sets the values of all the basic and advanced parameters, bringing them to the default
ones.
This function DOES NOT cancel the learned stroke and DOES NOT erase the learned remotes.
To perform recovery follow below steps:
•
Access the parameter by holding down the MENU button for 3 seconds.
•
When the display displays the value " 0 " release the button.
•
Press the MENU key and hold it until the countdown ends and the display displays " don ".
•
The procedure was successfully completed.
PARAMETER
dEF
Viewer memory location of a learned transmitter
With this parameter you can view the memory location assigned to a transmitter by the control unit during learning.
To do this follow the following steps:
•
Access the parameter by holding down the MENU button for 3 seconds.
•
When the display displays the value " SEE " release the button.
•
From this moment, the control unit is waiting for a known radio command. After 15 seconds without receiving any transmis-
sion, the control unit automatically exits the function displaying the message " tout ".
•
Transmit with your own remote control, the display will show the memory position (eg " 245 ").
•
More than one remote control can be displayed in the same session. To exit the function, briefly press the MENU button.
PARAMETER
TrS
32 - English - Translated from the original language
VALUES
OFF = disabled
from 1 to 20 multiplied by 100 ms
VALUES
OFF = disabled
from 1 to 247
VALUES
-
VALUES
DEFAULT
5 = 500 ms
DEFAULT
OFF
DEFAULT
-
DEFAULT
6-1622467M - rev. 0 - 07/03/2024