Publicidad
Idiomas disponibles
Idiomas disponibles
Cancellation of a single transmitter learned
With this parameter you can erase a single transmitter already learned, using its memory location. If this value is not known, refer
to the function "Viewer memory location of a learned transmitter".
Follow these steps to cancel:
•
Access the parameter by holding down the MENU button for 3 seconds.
•
When the display displays the value " 0 " release the button and use the UP and DOWN keys to set the memory position of
the remote to be deleted.
•
Confirm by holding down the MENU key for 3 seconds.
•
The display will show the message " CLR " to indicate the correct deletion.
•
If the memory location is empty, the message " Err "will be displayed.
•
You can delete more than one remote control in the same session. To exit the function, press the MENU key briefly.
PARAMETER
TrC
Deletion of all radio memory
With this parameter you can restore the radio memory.
This results in the deletion of ALL learned remotes.
To perform total cancellation follow below steps:
•
Access the parameter by holding down the MENU button for 3 seconds.
•
When the display displays the value " 0 " release the button.
•
Press the MENU key and hold it until the countdown ends and the display shows " don ".
•
The procedure was successfully completed.
PARAMETER
TrF
Setting PASSWORD
Allows you to set a 5-digit password for access to the menu.
The value "00000" disables the password and makes access to the menu free.
PARAMETER
PASS
6-1622467M - rev. 1 - 07/03/2024
VALUES
VALUES
VALUES
"00000" = free access
"XXXXX" = password set
DEFAULT
DEFAULT
DEFAULT
"00000"
Translated from the original language - English - 33
Publicidad
