Publicidad
Idiomas disponibles
Idiomas disponibles
3.7 - ELECTRICAL CONNECTIONS OF SIGNALLING DEVICES
# TERMINAL
3
4
5
The outputs are active during the opening and closing phases of the automation.
Refer to the advanced parameters to configure the flashing mode and the lighting time of the courtesy light.
3.8 - ANTENNA CONNECTION AND RADIO COMMUNICATION
• Do not place the control unit inside metal containers.
• The maximum range may vary significantly in the presence of metal parts, in the presence of shielding
between the transmitter and the control unit or in the presence of other devices that communicate at the
same radio frequency.
# TERMINAL
19
20
The board comes with a standard antenna already connected.
The LED RADIO present on the board, allows to have a visual feedback of the amount of radio noise
present in the surroundings of the automation. The more the LED is fixed and the greater the distur-
bances present.
In susceptible installations it is advisable to install an antenna at 433Mhz.
Install the external antenna and its cables in a place protected from damage and/or vibration and where
there are no obstacles between the transmitters and the antenna.
14 - English - Translated from the original language
FUNCTION
Common courtesy and flashing light output
Courtesy light
Flashing light
3
4
5
WARNING
FUNCTION
Antenna
Shield
INSTALLATION TIPS
DESCRIPTION
MAX 60 W
MAX 60 W
DESCRIPTION
Connect cable type RG58
6-1622467M - rev. 0 - 07/03/2024
Publicidad
