Descargar Imprimir esta página

Royal Catering RCSI-18A Manual De Instrucciones página 35

Máquina de helado suave

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 117
Disassembly and cleaning of components
a. Removing the screws : Remove the four mounting screws on the front of the dispenser
door and remove it.
b. b. Component Removal : Remove the handle pin, handle, plunger, plunger O-ring and
dispenser door O-ring.
c. Cleaning the tamper : Remove the tamper from the cooling tank and then remove the
tamper seal.
d. Inspection and replacement of worn parts : Place the disassembled parts in a
disinfectant solution. Check the tamper, tamper seal, O-rings and thrust sleeve. Replace
worn parts.
e. Lubrication and assembly : After cleaning, lubricate the parts with Vaseline. Install the
parts according to the disassembly procedure.
Final remarks
Lubrication : Before installing the piston and tamper, apply Vaseline to the seal
grooves to prevent accelerated wear. Regular lubrication can significantly extend the
life of components.
Cleaning the machine housing
Regular cleaning : To keep the machine's exterior clean, wipe it regularly with a wet towel.
Avoid direct rinsing : Do not rinse the machine housing directly with water to avoid damaging the
internal electrical components.
EN

Publicidad

loading