Abaxis VETSCAN VS2 Manual Del Usuario página 117

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

3.
In the Connect Using dialog, select the port that the ana-
lyzer is connected to, then click
not required.)
Note:
If the port is unknown, select any one for now. If
needed, you can run the wizard again to try other ports.
4.
Change Bits per second to
Leave all other settings at their defaults.
5.
If a valid port was selected, a new
HyperTerminal session starts. The
status pane on the lower, left corner
of the window should display "Con-
nected" as shown.
Note:
If an error message appears, close HyperTerminal (do not save changes). Start the
HyperTerminal setup wizard again, and choose a different port.
6.
Click
File > Save As
sion file is saved so that it can be loaded in the future (create a shortcut on the desktop if nec-
essary). Proceed to the next section for instructions on capturing results.
. (The other settings are
OK
, then click
9600
on the menu to save the HyperTerminal session. Note where the ses-
Connecting to an External Computer
.
OK
11-15

Publicidad

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Abaxis VETSCAN VS2

Tabla de contenido