Abaxis VETSCAN VS2 Manual Del Usuario página 23

3. Install a paper roll in the analyzer's printer.
a. Open the printer cover. If the printer contains a roll of paper, remove it.
b. Remove the wrapper from the paper roll,
then unroll several inches of printer paper.
c. Put the paper roll into the printer so that the
paper unrolls from the bottom of the roll and
out towards the front of the analyzer, as
shown.
d. Make sure several inches of paper extend
out of the printer slot, then press the cover
closed till it locks into place.
e. Pull gently on the end of the paper to make
sure it is taut.
4. Press the Power button to turn the analyzer on.
The analyzer then begins its
power-up cycle:
Note: If no display message appears (blank display), remove the plug from the adapter, re-
attach, and press in firmly. See
the analyzer self test. You may need to allow additional time for the heaters to warm the
analyzer to operating temperature.
"Quality Control Features" on page 7-1
Set Up and Analyzer Description
for details about
3-3