Initialising The Axon-Bus Gripping Component; Legal Information; Trademarks - Ottobock 8E600 Instrucciones De Uso

Removing the hook tip
1) Slide the cap nut cover over the hook tip and remove it.
2) Loosen the cap nut with the mounting wrench (see fig. 1).
3) Unscrew the cap nut (see fig. 2) and pull off the hook tip with the cap nut.
Mounting the hook tip
1) Place the hook tip on the connector of the gearbox (see fig. 4).
INFORMATION: Mount the hook tip so that the groove of the hook tip lies parallel over
the pin of the connector (see fig. 3).
2) Screw on the hook tip.
3) Tighten the hook tip with the mounting wrench (see fig. 5).
INFORMATION: The hook tip must be tightened using a torque of 17 Nm.
4) Pull the cap nut cover over the hook tip and position it over the cap nut.

10.2 Initialising the Axon-Bus gripping component

The Axon-Bus gripping component is delivered in an initialised state.
NOTICE
Pulling the Axon-Bus gripping component off during operation/controlling
Loss of maximum speed and loss of closing movement.
The product must be re-initialised after being attached to the socket.
►
1) Attach the Axon-Bus gripping component to the socket (Changing the Axon-Bus gripping
component).
2) Open the hook tips completely. The hook tip touches the stop.
3) Close the hook tips completely.
INFORMATION: There must be no objects between the hook tips.
→ The Axon-Bus gripping component is now initialised. The complete opening width and maxim­
um speed can be used once again.

11 Legal Information

11.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.

11.2 Trademarks

All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
11.3 CE Conformity
This product meets the requirements of the European Directive 93 / 42 / EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
24 | Ottobock