Place Fiber; Adjust Monitor Angle - ADInstruments AD300 Manual De Usuario

_____________________________________________________________________
2.7.5 Hold the cutter by left hand and open the big clip by right hand
and romove the fiber chips to put them in fixed containers.
2.7.6 Pinch and hold the fiber with the left hand, and open the small
clip with the right hand at the same time, and carefully remove
the fiber.
Notes: the clean cross-section of fiber can not touch other things.

2.8 Place fiber

2.8.1 Open shielding cover and left and right fiber clips.
2.8.2 Put the good fiber end face in the V-shaped
groove, ensure the tip of the fiber between
the tip of the electrode and V-shaped groove's
edge.
If the fiber is bending, bending part should be
z
upward when placing the fiber.
To ensure the splice quality of the fiber, the clean cross-section of
fiber can not touch other things.
2.8.3 Use fingers to pinch the fiber, and then close the left clip, and
press the fiber. Ensure the fiber is placed in the bottom of
V-shape groovy. If the fiber is placed incorrect, please replace
the fiber. The fiber end face don't touch the V-shape groove
when place the fiber.
2.8.4 Place another optical fiber according to the above steps.
2.8.5 Close shielding cover.

2.9 Adjust Monitor Angle

2.9.1 The monitor hinge that fixes the monitor frame may become too
loose and does not maintain the monitor position. To fix this
problem, tighten monitor hinge screws as is shown in the
following picture.
©Copyright Abacanto Digital SA.
Manual de usuario AD300
AD Instruments
112