Cleaning V-Grooves - ADInstruments AD300 Manual De Usuario

_____________________________________________________________________
<5> Double press
For example, to change the name "Auto SM" into "Auto
NZ" in the above screens:
5
Critical cleaning points and maintenance checks are described below.

5.1 Cleaning V-grooves

If contaminants are present in the V-grooves, proper clamping may not
occur, resulting in higher splice loss. The V-grooves should be frequently
inspected and periodically cleaned during normal operation. To clean the
V-grooves do the following:
<1> Open the wind protector.
<2> Clean the bottom of the
V-groove
With an alcohol-impregnated thin
cotton
swab. Remove excess alcohol
from
the V-groove with a clean dry
©Copyright Abacanto Digital SA.
operation interface
E. Press
for six times and move the "upper cursor"
to "S";
F. Press
cursor" onto the letter "N" on the Soft Keyboard;
G. Press
to confirm. The letter "N" is then put onto
the position of "S"; thus the letter "N" replaces the
letter "S".
H. Use the similar method to input "Z".
Manual de usuario AD300
to return to "Splice Mode menu"
or
and move the "lower
AD Instruments
168