ADInstruments AD300 Manual De Usuario página 124

_____________________________________________________________________
Parameter
Est. Mode
MFD-L
MFD-R
Minimum Loss
Core Step coefficient
Core curve coefficient
MFD Mismatch
Note1: editing splice parameter files
D. In the interface of "editing splice parameter files" list, press
then press
E. Press
settings, and then press
F. Press
interface.
The screen displays as follows when the choice is entered:
Note2: Descriptions about Referring or editing splice mode
©Copyright Abacanto Digital SA.
Selects splice loss estimation mode to "OFF",
"CORE", or "CLAD".When MM fibers are spliced,
select "CLAD".
Sets MFD of the left and right fibers. Both MFD-L
& R are taken into account for estimating splice
loss.
This amount is added to the estimated splice loss
originally calculated. When splicing specialty or
dissimilar fibers, a high actual splice loss may
occur even with optimized arc conditions. To make
the actual splice loss concur with the estimated
splice loss, set the minimum value of estimate to
the minimum optimized actual splice loss.
Determines how Core step, Core curve and MFD
mismatch influences splice loss estimate. If Est.
Mode is set "OFF" or "CLAD", these Core step,
Core curve and MFD mismatch are automatically
set "OFF". If the estimated splice on certain fiber
combinations needs adjustment, Core step, Core
curve and MFD mismatch are used. These are
advanced splicer functions and should be discussed
with your representative before changing.
and move the cursor to select an item to change, and
to enter.
or
one by one to return to the previous operation
Manual de usuario AD300
AD Instruments
Description
to change the parameter or
to confirm the change.
124