ENGLISH
All material should be eliminated in compliance with statutory regula-
tions.
The generator does not present any particular risks or hazards during
dismantling. To aid recovery of the material, it is best to classify it by
type (i.e. electrical parts, copper, aluminium, plastic, etc.).
10. SPARE PARTS AND AFTERSALES
10.1 Aftersales procedure and contact addresses
Our Aftersales Service provides a comprehensive technical advise
service. When requesting assistance under warranty make sure that the
generator identification data is on hand including its serial number and
production lot as shown on the adhesive label whose position is given
in section 3.2 of this manual. The list of authorised aftersales assistance
centres can be found on our homepage: www.sogagroup.com
11. WARRANTY
Sincro S.r.l. guarantees the own alternators and welders for a period of
12 months starting from the invoice issue date. We confirm that warranty is
directed only to Sincro customers to which we respond. Sincro does not
grant warranty to those who have not directly purchased the product from
the factory, in spite of the possession of it.
Within the above mentioned terms, Sincro commits itself to supply free of
charge those spare parts that, according to its judgment or to the one of an
authorized representative, appear with manufacturing or material defects
or, always to its judgment, to directly or through an authorized centre carry
out the repairing without undertaking transport costs.
We anyhow exclude forms of responsibility or obligation for other costs,
damages and direct or indirect loss caused by the total or partial usage or
impossible usage of the products.
The repairing or the substitution will not extend or renew the warranty dura-
tion.
Warranty will not be granted: whenever break-downs or problems may ap-
pear because of lack of experience, usage over the nominal performances,
if the product had been modified or should return incomplete, disassembled
or with modified nameplate data.
28 - HB - Maggio 2004 - Rev. 00