Electro-Magnetic Compatibility Tables - Enraf Nonius Endolaser 422 Manual De Uso

10 Electro-magnetic compatibility tables

Guidance and manufacturer's declaration – electromagnetic emissions 230Vac
The ENDOLASER 422 is intended for use in the electromagnetic environment specified below.
The customer or the user of the ENDOLASER 422 should assure that it is used in such an environment.
Emissions test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic emissions 115 Vac
The ENDOLASER 422 is intended for use in the electromagnetic environment specified below.
The customer or the user of the ENDOLASER 422 should assure that it is used in such an environment.
Emissions test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity
The ENDOLASER 422is intended for use in the electromagnetic environment specified below. The customer or the
user ENDOLASER 422 should assure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD) (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power
supply input lines
IEC 61000-4-11
Compliance
Group 1
Class A
Class A
Complies
Compliance
Group 1
Class A
Not Applicable
Not Applicable
IEC 60601
Test level
± 8kV contact
± 2; 4; 8; 15 kV air
±2kV for power
supply lines
± 1 kV for input / output
lines
± 1kV line(s) to line(s)
± 2kV line(s) to earth
0% U for 0,5 cycles
T
0% U for 1 cycle
T
Electromagnetic environment
The ENDOLASER 422 uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
The ENDOLASER 422 is suitable for use in all
establishments, excluding domestic establishments and
those directly connected to the public low voltage power
supply network that supplies buildings used for domestic
purposes .
Electromagnetic environment
The ENDOLASER 422 uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment.
The ENDOLASER 422 is suitable for use in all
establishments, excluding domestic establishments and
those directly connected to the public low voltage power
supply network that supplies buildings used for domestic
purposes .
Compliance level
Floors should be wood, concrete or
± 8kV contact ceramic tiles. If the floors are coated
with synthetic material, the relative
humidity should be at least 30%.
± 2; 4; 8; 15 kV air
± 2kV for power
The quality of the mains voltage should
supply lines
be that of a typical commercial or
± 1 kV for input /
hospital environment.
output lines
± 1kV line(s) to
The quality of the mains voltage should
line(s)
be that of a typical commercial or
± 2kV line(s) to
hospital environment.
earth
for 0,5 cycles The quality of the mains voltage should
0% U
T
be that of a typical commercial or
hospital environment. If the user of
ENDOLASER 422 requires continued
0% U for 1 cycle
T
operation during mains power outages,
Electromagnetic environment
EN
27