Operating The Pressure Cooker - WMF Perfect Premium Manual Del Usuario

e)
Lift the lid by the handle
6
2. Take apart the lid (see image series G), by
first turning the lid over
3. Carefully pull the seal ring
's rim and place aside.
4.
Hold the lid and press the handle locking
6
device towards the end of the handle.
E
5. Remove the lid by the handle.
6
5.2 First clean the pressure cooker
1.
Take the pressure cooker apart as described in
Chapter 5.1.
2. Fill 2/3 (see inner scaling Image I) of the pot
with water and add 2-3 tablespoons of
1
household vinegar.
3.
Boil the vinegar water in the pot
the lid for about 5-10 minutes.
6
4.
Afterwards, wash all parts thoroughly by hand.
5. Dry all parts well after cleaning.
5.3 Assembling the pressure cooker
CAUTION
RISK OF BURNS CAUSED BY
INCORRECTLY ASSEMBLED LID
The lid cannot be put together incorrectly.
Assembly must follow the manner described.
⇨
Observe the instructions strictly.
⇨
Check for correct fit.
5.3.1 Assemble the lid
(see image series H)
1. Check lid rim, lid handle, safety devices
and seal ring for dirt or clogging.
2. Turn lid so that the rim points
6
downward.
3.
Turn the handle
4. Insert the holding slot
handle into the lid's
B
5.
Slowly fold down the lid
64.1168.0790 I 002
Operating Instructions
.
B
.
6
out of the pot
L
without
1
and hold in place.
B
on the lid
H
holder .
6 8
.
6
6. Turn lid using the handle
6
7. Position the lid
way that the double seal
the edges of the lid opening damaged.
8.
Carefully press down lid
place audibly in the handle locking device
Check that it is correctly seated by pressing
on the red slider.
9.
Insert the seal ring
carefully press under the rim.
▶
The seal ring
L
completely below the curved pot rim.
5.3.2 Put lid on ((see image series F)
1.
Place pot on firm surface.
1
2.
Place lid on the pot
6
downwards.
▶
The placement marking
handle marking
the lid cannot be put on.
▶
Seal ring must be inserted into the lid
L
rim!
3. Hold the pot's
1
hand.
4.
With the right hand, swivel the lid
the handle to the left.
B
5. When both handles
exactly on top of each other, push the turn
knob forwards completely.
C
▶
No gap can be visible between the handle
and the turn knob

6. Operating the pressure cooker

6.1 Check safety devices
1.
Remove lid as described in Chapter 5.1.
6
2. Carefully pull the seal ring
rim and place aside.
3.
Remove lid handle
B
4.
Check to ensure that the seal ring
inner lid rim are clean.
.
B
and handle in such a
6 B
isn't squished or
I
until it snaps into
6
into the pot's rim and
L
must be positioned
with rim facing
1
on the lid and the
9
must line up, otherwise
4
handle with the left
3
with
6
/ are lined up
3 B
.
C
out of the pot 's
L
as described in Chapter 5.1.
and the
L
EN
.
E
B
29