Clutch - Honda NXR150 Bros KS Manual Del Propietário

Owner´s Manual

Clutch

Clutch adjustment may be required if the motorcycle
stalls when shifting into gear or tends to creep; or if
the clutch slips, causing acceleration to lag behind
engine speed.
Minor adjustments can be made with the clutch cable
adjuster (4) at the clutch lever (1).
Normal clutch lever free play is:
10 – 20 mm (0.4 – 0.8 in)
(1)
1. Pull back the rubber dust cover (2).
2. Loosen the lock nut (3) and turn the adjuster (4).
Tighten the lock nut and check the adjustment.
3. If the adjuster is threaded out near its limit or if the
correct free play cannot be obtained, loosen the
lock nut and turn in the cable adjuster completely.
Tighten the lock nut and install the dust cover.
(1) Clutch lever
(3)
(A)
(B)
4. Loosen the lock nut (5) at the lower end of the
cable. Turn the adjusting nut (6) to obtain the
specified free play. Tighten the lock nut and check
the adjustment.
5. Start the engine, pull in the clutch lever and shift
into gear. Make sure the engine does not stall and
the motorcycle does not creep. Gradually release
the clutch lever and open the throttle. The
motorcycle should begin to move smoothly and
accelerate gradually.
(2) Dust cover
(3) Lock nut
(2)
(4) Adjuster
(A) Increase free play
(B) Decrease free play
(4)
23