Normal operation
The door area and the area of the cooler and the safety valves at the rear of the device can become hot while the
n
device is switched on and remain hot for a long time after it is switched off.
The sterile filter is no longer effective if it has become wet. Stop using the sterile filter and replace it.
n
Do not replace the sterile filter during a program run.
n
Program abort
Please observe that opening the door following a program abort can lead to hot steam leaving the sterilization cham-
n
ber.
Observe the instructions shown on the display of the device. Sterilize the affected
n
Maintenance
Maintenance should only be performed by
n
Maintain the specified servicing intervals.
n
Only original MELAG spare parts may be used.
n
Repair
Never open the device housing. Incorrect opening and repair can compromise electrical safety and pose a danger to
n
the user. The device may only be opened by an
Malfunctions
Should the device issue the same malfunction message repeatedly, turn off the device and if necessary, inform your
n
stockist.
The device may only be serviced by
n
Notification requirement in the event of serious accidents in the European Economic Area
Please note that all serious accidents which occur in connection with the medical product (e.g. death or serious dete-
n
rioration in the state of health of a patient) which were presumably caused by the product, must be reported to the
manufacturer (MELAG) and the relevant authority of the member state, in which the user and/or patient resides.
authorized
technicians.
}
authorised technician
}
authorized
technicians.
}
load
after re-wrapping.
}
who must be a
qualified
electrician.
}
2 Safety
7