Mectron combi touch Manual De Uso Y Mantenimiento página 188

combi touch
On the quick coupling of the cord, slide
the ring and hold it in position, then
extract the air-polishing handpiece, and
finally release the ring of the handpiece;
If the PERIO air-polishing handpiece was
used, remove the SUBGINGIVAL PERIO
TIP using the supplied K9 wrench and
proceed with disposal (see
page 102 );
NOTE: Insert the K9 wrench exactly in
the position shown in the figure.
CAUTION: Before extracting the
powder container or unscrewing
the caps, check that the appliance is
switched off and disconnected from the
power mains, or run the "refill" function
(see Chapter 5.6.1 on page 38
Extract the powder container from
the appliance, remove
and empty it.
Proceed with polishing. (see
on page 101 )
Repeat the operation on the second
powder container of the appliance if both
have been used.
When the cleaning operation has been
completed, re-position the containers in
the appliance.
CAUTION: Insert the powder
containers in such a way that the groove
of the bottom of the appliance is
aligned with the convexity of the powder
container.
48
8
9
Chapter 10 on
10
).
the cap
Chapter 9.4
11