Siemens SINAMICS DCM Manual página 762

From sequence control [2650]
From sequence control [2650]
From sequence control [2650]
[3125.8]
From sequence control [2650]
From sequence control [2650]
From sequence control [2650]
From sequence control [2650]
From sequence control [2650]
Bit 9 = 1 Ready to exchange process data
From sequence control [2650]
[2750.7]
From sequence control [2650]
From sequence control [2650]
<1> The drive object is ready for acceptance.
1 2
DO: DC_CTRL
Internal control/status words - Status word, sequence control
PROFIdrive bit
Bit No.
0 1 = Ready for switching on
1 1 = Ready
2 1 = Operation enabled
Jog ON cmd
r53170.8 3 1 = Jog active
4 1 = No coast down active (OFF2 inactive)
5 1 = No Quick Stop active (OFF3 inactive)
6 1 = Switching on inhibited active
7 1 = Drive ready
8 1 = Controller enable
9 1 = Control request
10 Reserved
11 1 = Pulses enabled
Close brake inv
r53210.1 12 1 = Open holding brake
13 1 = Command close holding brake
14 1 = Pulse enable from the brake control
0 15 1 = Setpoint enable from the brake control
3 4
Status word sequence control
<1>
5 6
fp_2585_13_eng.vsd
20.08.18 V01.05.00
16000 μs
ZSW seq_ctrl
r0899
r0899.0
r0899.1
r0899.2
r0899.3
r0899.4
r0899.5
r0899.6
r0899.7
r0899.8
r0899.9
r0899.11
r0899.12
r0899.13
r0899.14
r0899.15
7 8
Function diagram
- 2585 -
SINAMICS DCM