HPA-Faip M 624 2V FS Uso Y Mantenimiento página 46

Vertical and horizontal limit stops do not operate
No air is passing through the control valve
- Renew control valve
Faulty tower tilt cylinder
- Renew tower tilt cylinder
No air supply to cylinder
- Renew cock
Air escapes from cock
- Renew cock or tower tilt cylinder
Arm and vertical slide locking cock leaks air
Valve seal damaged
- Renew cock
Incorrect release valve setting
- Adjust (Fig. 23)
Hares: increase speed
Tortoise: decrease speed
Tyre pressure gauge needle fails to return to 0
Pressure gauge faulty or damaged
- Renew pressure gauge
SIMPESFAIP declines all liability for claims deriving from the use of non-original spares
or accessories.
It is expressly forbidden to attempt to alter operating pressure of the relief valves or the
pressure regulator.
The manufacturer declines all liability for damage resulting from tampering with these
components.
Before making any adjustments or carrying out maintenance, disconnect the electrical
supply from the machine and make sure that all moving parts are suitable immobilised.
Do not remove or modify any parts of this machine except in the case of service
interventions.
Tower does not tilt
The tower tilts violently or slowly
MAINTENANCE
WARNING
WARNING
WARNING
WARNING
21