Mymodes; Switching Mymodes With The Cockpit App - Ottobock Genium-Bionic Prosthetic System 3B1 Instrucciones De Uso

PreFlex
PreFlex ensures the knee is in 4° of flexion at the end of swing phase in preparation for loading
response. This makes initiating stance phase flexion easier and forward movement is less restric­
ted.
Adaptive yielding control
The knee joint has auto-adaptive stance and swing extension resistance. The stance flexion resist­
ance experienced by the user is dependent on the slope or incline when walking downhill. When
walking on a ramp, adaptive yielding control manages flexion depending on the angle of the ramp.
The knee joint flexes slowly if the ramp is flat, and flexes quickly if the ramp is steep.
Dynamic stability control (DSC)
DSC ensures the knee will not release stance resistance during biomechanically unstable static
and dynamic conditions. Constantly checking multiple parameters, DSC ensures the optimally
timed decision for the knee to safely switch from stance to swing. Because DSC is always monit­
oring knee function, multi-directional movement and walking backward are also possible without
risk of stance resistance releasing.
Adaptive swing phase control
Instantaneous adaptation to varied walking cadences and to changes of the pendular mass (e.g.
varying footgear) ensures the knee always achieves the swing flexion target angle within (+/-) one
degree. The swing phase extension and flexion resistance experienced by the user are auto-
adaptive.
The flexed and partially loaded knee will also disable the stance phase on slopes and ramps to
allow for greater knee flexion and more ground clearance in the swing phase.

9 MyModes

With the help of adjustment software, the O&P professional can activate and configure up to
5 MyModes in addition to the basic mode. These can be selected by using the Cockpit app. Only
the first 3 MyModes can be selected using movement patterns. Switching by using movement
patterns has to be activated in the adjustment software by the O&P professional.
These modes are intended for specific motion patterns or postures (e.g. inline skating...). Set­
tings can be adjusted using the Cockpit app (see Page 86).
Only when "DUAL" marking is not present (see Page 60)
For information on switching MyModes with the remote control (optional accessory), see the
remote control instructions for use.

9.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
89