Hunter AutoComp Elite Instrucciones Funcionamiento página 8

Tool Holder Shaft Locking Bolt
Image 6.
By loosening the tool holder shaft locking bolt, the cutting tool holder
bar may be slid along the cutting tool slide . This allows for proper
alignment of the cutting tool holder bar and the disc being machined .
After proper alignment is achieved, the tool holder shaft locking bolt
should be lightly tightened .
Trolley Height Adjustment
The trolley lift strut can be adjusted to accommodate low and high
operational ranges . The low range of travel is 514 .35 mm to 920 .75
mm (20 .25 in . to 36 .25 in . ) , as measured from the lathe output
shaft centerline to the floor . The high range is 622 .3 mm to 1028 .7
mm (24 .5 in . to 40 .5 in . ) as measured from the lathe output shaft
centerline to the floor .
The lift strut contains highly pressurized gas and is
under compression in the trolley at all times.
Lock the carriage in place using the provided locking pin, then
remove the stop bolt at the top of the column .
Push down on the carriage to unload the stop pin and then remove
the pin . Slowly release the carriage and allow the strut to fully
extend .
Image 8.
Lift the carriage to pull the strut out of the trolley base, install the
strut into the lower position .
Image 9.
Push the carriage down and pin it in position, then reinstall the stop
bolt .
Lathe Tablet Operation Lathe Tablet Operation
Basic Operation
Power on / off
Users power the lathe tablet on and off by pressing the small button
on the top edge, with the tablet oriented so the ASUS logo is on the
right hand side .
Navigating
Press the screen and swipe to navigate or scroll .
Making Selections
Press buttons to make selections . Press, hold and swipe to move
sliders in the tablet interface . Many sliders can also be moved by
touching the option title:
Lathe Controls
Select vehicle
Swipe the tablet on the main screen to access the main menu . Touch
"Change Vehicle" to select the vehicle currently being serviced .
Image 10.
Users can either touch the top button to navigate through a
vehicle list . After choosing the desired make and model, users are
presented with vehicle specific information .
Image 11. Screen for lathes Outside N. America
Touch the button labeled with the correct axle of the vehicle being
serviced, either front or rear . For lathes in N . America the correct
adaptor, lug nut torque and other pertinent information to the service
will be displayed .
6
Image 7.
Main Screen Features
BitMinder
From the main screen, touch "BitMinder ." From the BitMinder screen,
users can view bit life data, a brief video on how to rotate bits, bit
history, and bit replacement .
Image 12.
Change Vehicle
Touch this button to choose the vehicle that is currently being
serviced .
Direction
Reverse rotation is used on some vehicles when excess drag on the
vehicle drivetrain prevents normal on-car operation . The twin cutter
insert holders must be flipped over when using the reverse function .
A brief video illustrates how to change the direction of the tooling .
The forward/reverse orientation is noted in the top right of the tablet
screen . This feature is enabled / disabled in set up .
Menu
From the main screen, touch "Menu ." From this menu, users can
choose set up options, as well as view training videos and usage/
ROI (Return On Investment) statistics .
English