Publicidad
Idiomas disponibles
Idiomas disponibles
Manual (Laydown) Tower Models
2
C
G
B
A
E
D
Ref
Description
A
Tongue Jack
B
Safety Chains (2)
C
Locking Pin
D
Winch Handle
E
Front Outrigger and Stabilizer Jack (2)
F
Rear Stabilizer Jack
G
Outrigger Retention Pin
H
Left Door and Engine Access
I
Tower Winch
J
Lamp Fixture (4)
K
Manual Tower
Pre-Operation Checklist
Perform the following checks before transporting
and operating the unit, when performing general
maintenance, and after the light tower has been stored or
idle for a period of time.
WARNING
Unsafe Operation Hazard
Operating or transporting the machine with worn,
damaged or missing parts can result in death or serious
injury. Always replace worn, damaged or missing parts
promptly. Do not transport or operate the machine until all
worn, damaged or missing parts have been replaced, and
proper operation of the machine has been verified.
NOTICE
We encourage the use of authorized replacement
Allmand parts. The warranty does not cover damage or
performance problems caused by the use of parts that
are not authorized replacement parts.
I
K
J
H
F
1. Check that all safety and operation decals are
present and legible. See Safety - Safety Decals.
2. Check that all operator's manuals (product, engine,
generator, etc.) are with the unit.
3. Check the following components for wear and
damage, and for proper operation:
A. Tongue jack
•
Check for rust or damage. Repair or
replace as needed.
•
Check for proper operation. See
Transporting - Using The Tongue Jack.
B. Hitch Assembly (trailer coupler / lunette ring)
•
Check for rust or damage. Repair or
replace as needed.
•
Check for proper operation. See
Transporting - Coupling And
Uncoupling The Trailer Hitch.
•
Check hardware for proper tightness.
Tighten as needed.
C. Safety chains
•
Check for rust or damage. Repair or
replace as needed.
•
Check hardware for proper tightness.
Tighten as needed.
D. Trailer lighting cable
•
Check for cut, frayed or bare wires.
Repair or replace as needed.
•
Check connector for damage. Repair or
replace as needed.
E. Tires
•
Check for wear, cuts, cracks, etc.
Replace as needed.
•
Check and adjust inflation pressure.
See Specifications for proper inflation
pressure.
F. Axle and undercarriage
•
Check for rust or damage. Repair as
needed.
G. Outriggers and stabilizer jacks
•
Check for rust or damage. Repair or
replace as needed.
•
Check for proper operation. See
Operation - Using The Outriggers &
Stabilizer Jacks.
H. Electrical wiring
•
Check for cut, worn or bare electrical
wiring. Repair as needed.
WARNING
Electrocution Hazard
Operating the unit with cut, worn or bare electrical
wiring could result in death or serious injury. Repair
or replace damaged wiring before operating the
light tower.
en
11
English
Publicidad
