Milwaukee Allmand NIGHT-LITE PRO II Manual Del Operario página 20

2. Set the tower arms to the preferred work angle.
A. Loosen the adjustment nut (B, Figure 14) on
each tower arm.
B. Pull the park pin (C, Figure 14) and rotate 90°
to unlock the tower arm.
C. Rotate each tower arm to the preferred work
angle.
D. Tighten the adjustment nuts.
3. Set each individual light fixture to the preferred work
angle.
• Yoke center pivot (D, Figure 14) - adjusts the
horizontal angle of each individual light fixture.
Grasp the sides of the yoke to adjust.
• Fixture pivots (E, Figure 14) - adjust the vertical
angle of each individual light fixture. Move the
light fixture up or down to adjust.
14
D
C
Manual (laydown) towers – LED
1. Set each individual light fixture to the preferred work
angle.
• Yoke center pivot (A, Figure 15) - adjusts the
horizontal angle of each individual light fixture.
Grasp the sides of the yoke to adjust.
• Fixture pivots - adjust the vertical angle of each
individual light fixture. Loosen the locking clasp
(B, Figure 15), move the light fixture up or
down to adjust, then tighten the locking clasp.
2. The light tower can also be rotated to provide
additional adjustment of the light angle. See
Operation - Raising And Lowering The Light
Tower.
20
E
B
A
15
B
Manual (laydown) towers – metal halide
1. Set each individual light fixture to the preferred work
angle.
• Yoke center pivot (A, Figure 16) - adjusts the
horizontal angle of each individual light fixture.
Grasp the sides of the yoke to adjust.
• Fixture pivots (B, Figure 16) - adjust the vertical
angle of each individual light fixture. Move the
light fixture up or down to adjust.
2. The light tower can also be rotated to provide
additional adjustment of the light angle. See
Operation - Raising And Lowering The Light
Tower.
16
B
A
A
www.allmand.com