Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Unsafe Operation Hazard
Failure to properly install safety chains could result in
death or serious injury. Always properly install safety
chains.
6. Connect the trailer lighting cable.
A. Make sure the trailer lighting cable mates with
the tow vehicle lighting cable. If needed, install
the proper cable and/or connector to the tow
vehicle.
B. Connect the trailer lighting cable to the tow
vehicle lighting cable (B, Figure 5).
C. Make sure there is adequate slack to allow for
turning without allowing the cable to drag on
the ground.
D. Check the trailer lights for proper operation.
WARNING
Unsafe Operation Hazard
Failure of trailer lights to operate properly could result in
death or serious injury. Always check for proper operation
of trailer lights, and repair or replace as needed.
5
7. Retract the tongue jack. See Transporting - Using
The Tongue Jack .
8. Remove the wheel chocks.
9. The trailer is now ready for towing.
To disconnect the trailer from the tow
vehicle
1. Chock the wheels.
2. Deploy the tongue jack. See Transporting - Using
The Tongue Jack.
14
B
A
3. Disconnect the trailer lighting cable from the tow
vehicle lighting cable.
4. Remove the safety chains from the safety chain
pockets on the tow vehicle.
5. Uncouple the trailer hitch from the tow vehicle hitch.
See Transporting - Coupling And Uncoupling The
Trailer Hitch.
6. Move the tow vehicle away from the unit.
Using The Tongue Jack
The unit is equipped with a tongue jack to raise and lower
the trailer tongue, and to level the trailer front-to-rear.
To deploy the tongue jack
1. Remove the jack locking pin (A, Figure 6).
2. Rotate the tongue jack 90° into the operating position
(B, Figure 6). Install the jack locking pin (C).
WARNING
Unsafe Operation Hazard
Failure to install the jack locking pin could result in death
or serious injury. Be sure the tongue jack is locked in the
operating position with the jack locking pin.
3. Unfold the jack handle into the operating position (D,
Figure 6).
To lower the jack foot (raise the trailer tongue)
•
Turn the jack handle clockwise (E, Figure 6) to lower
the jack foot (F) and raise the trailer tongue.
To raise the jack foot (lower the trailer tongue)
•
Turn the jack handle counterclockwise (G, Figure 6)
to raise the jack foot (H) and lower the trailer tongue.
To retract the tongue jack
1. Be sure the trailer is securely supported by the tow
vehicle or other approved means.
WARNING
Unsafe Operation Hazard
Failure to support the trailer tongue before retracting
the tongue jack could result in death or serious injury.
Be sure the trailer tongue is securely supported before
retracting the tongue jack.
2. Fully raise the jack foot.
3. Fold the jack handle into the transport position (I,
Figure 6).
4. Remove the jack locking pin.
5. Rotate the tongue jack 90° into the transport position
(J, Figure 6). Install the jack locking pin.
www.allmand.com
Publicidad
