Milwaukee Allmand NIGHT-LITE PRO II Manual Del Operario página 25

Idiomas disponibles

Power is supplied to the outlets when the engine is

running and the main breaker (A, Figures 24 through 28)

is ON.

Each outlet is protected by a dedicated circuit breaker. If

a breaker trips:

1. Disconnect the load from the outlet.

2. Turn off the tower lights or shut off the engine.

3. Wait 10 minutes for the generator to cool down.

4. Correct the load problem.

5. Start the engine or turn on the tower lights.

6. Reset the breaker.

Note: Be sure to also check the GFCI breaker on the

GFCI outlet (if equipped), and reset if necessary.

7. Reconnect the load.

8. If the problem persists, see Troubleshooting.

Shutting Down The Unit

1. Shut down the tower lights. See Operation -

Operating The Tower Lights.

2. Shut down the engine. See Operation - Operating

The Engine.

3. Lower the light tower. See Operation - Raising And

Lowering The Light Tower.

4. Adjust the lights to the transport position. See

Operation - Adjusting The Tower Lights.

WARNING

Burn Hazard

Handling hot light fixtures could result in serious injury.

Allow lights to cool before handling, or use heat- resistant

gloves.

5. Retract the stabilizer jacks and outriggers. See

Operation - Using The Outriggers & Stabilizer

Jacks.

6. The unit is now ready for transport. See

Transporting.

English