Ambient Working Conditions; Electrical Hook-Up; Safety Regulations - Corghi EXACT 70 II Manual De Uso

ATTENTION
Make sure that there are no permanent mag-
nets, electromagnets or large heat sources
close to the equipment (they might damage
the program disk and the Personal Computer
beyond repair).

Ambient working conditions

Relative humidity 20% - 80%.
Temperature range 0°C - 40°C.
WARNING
Use of the equipment in a potentially explosive
atmosphere is not permitted.

ELECTRICAL HOOK-UP

The manufacturer pre-sets the aligner to operate
with a power supply of 230V AC. To change this
setting, refer to the "installation" section.
WARNING
Any connections to the workshop electrical
board are the customer's responsibility, and
must be made by staff qualified in accordance
with the relevant legal requirements.
- The electric hook-up must be suitably rated
in relation to:
• The machine input power, specified on the
machine data plate.
• The distance between the equipment and
the electric hook-up point, so that voltage
drops under full load do not exceed 4% (10%
during start-up) below the rated voltage
specified on the dataplate.
- The user must:
• fit a power plug in compliance with the cur-
rent regulations on the power supply lead;
• connect the equipment to its own electri-
cal connection having a specific automatic
differential circuit-breaker, with sensitivity
30 mA;
• fit protection fuses to protect the power
supply line, rated in accordance with the
instructions provided in the general wiring
diagram in this manual;
• provide the workshop's electrical system
with a grounding circuit in good working
order.
52
- In order to prevent the equipment being used
by unauthorised personnel, it is advised to
disconnect the power supply plug when the
equipment remains idle (switched off) for long
periods of time.
- If the equipment is connected directly to the
power supply by means of the main electrical
board without the use of a plug, a key switch or
device with padlock fixture must be provided
to restrict use of the equipment to authorised
personnel only.
WARNING
A good grounding connection is essential for
correct operation of the equipment.
NEVER connect the earth wire to a gas or water
pipe, telephone wire or any other unsuitable
objects.
WARNING
Before connecting the power supply plug to the
power panel make sure that the line voltage is
the same as the power supply indicated on the
machine data plate.

SAFETY REGULATIONS

The equipment is intended for professional
use only.
WARNING
Only one operator may work on the equipment
at a time.
WARNING
Failure to comply with the instructions and
danger warnings may cause serious injury to
operators and to others in the vicinity.
Before starting up the equipment, always ensure
you have read and understood all the danger/
warning signs in this manual.
Only qualified, authorised operators are capable
of using this equipment correctly. In order to be
classified as skilled, operators must be capable of
understanding the written instructions provided
by the producer, and be trained and familiar with
the safety rules and labour regulations.
Operators must not use the equipment under
the influence of alcohol or drugs which may af-
Operator's Manual EXACT 70 II