Program Step Recall; General Functions - Corghi EXACT 70 II Manual De Uso

Last job Restarts the wheel alignment
procedure by loading the data of the job just
completed.
Shutdown Activates the program closure
and wheel aligner switch-off procedure.
Help Recalls the information for the
current video page to the screen.
The on-line instructions back up the Operator's
Manual but do not replace it in all respects.

Program step recall

Diameter selection Recalls input of the
rim diameter to be used in toe measurements
in millimetres / inches.
Chassis height For vehicles where this
is necessary, recalls input of the chassis heights
necessary to obtain the databank references.
Steering angle Recalls the steering
lock procedure for measurement of the caster,
king pin, steering angle difference at 20° and
maximum steering angle.
Data summary Recalls the summary of
the vehicle data.
Front axle Recalls the front axle adjust-
ment step.
Rear axle Recalls the rear axle adjust-
ment step.
Data summary and printout Recalls
the job data summary, printout and save step.
End of session Ends the current job
and returns to the main menu.
Vehicle adjustment Selects the help
function for adjustment of the vehicle. Only the
help selections available are active.
58
Vehicle selection Recalls selection of
the vehicle from the databank.
Databank data summary Recalls the full
summary vehicle's databank references.
Chassis situation Recalls the vehicle
chassis situation step.
EZShim Recalls the EZShim calcula-
tion program.
Toe curve Recalls the toe curve checking
and adjustment procedure.
Distronic Adjustment Recalls the align-
ment screen for the equipment for adjusting the
Mercedes "Distronic" anti-collision radar system.
Bar kit In truck and trailer alignment
mode, it enables alignment with the acces-
sories for reference to the axis of symmetry of
the chassis.
Log Recalls the logs screen. Active
for calibration procedures and other utility
programs.
Sensor cross-check Sensor cross-check
procedure for checking calibration.
Chassis misalignment In the truck
and trailer procedure, it recalls the screen that
supplies the estimate of the vehicle's degree of
crookedness.
Visual check Recalls the procedure for
visual checking of the vehicle.
Vehicle weight Recalls the procedure for
acquiring and adjusting the vehicle's axle weight.

General functions

Continue Moves on to the next program
step in the pre-set sequence.
Operator's Manual EXACT 70 II