fect their capacity. In all cases, it is essential to:
- Be able to read and understand all the infor-
mation in this manual.
- Have a thorough knowledge of the capabilities
and characteristics of this equipment.
- Keep unauthorised persons well clear of the
area of operations.
- Make sure that the equipment has been
installed in compliance with all the relevant
legislation and standards.
- Make sure that all system operators are suit-
able trained, that they are capable of using
the equipment correctly and safely and that
they are adequately supervised during their
work.
- Not touch power lines or electrical equipment
without first making sure that the power supply
has been disconnected.
- Read this manual carefully and learn how to
use the equipment correctly and safely.
- Always keep this operator's manual in a place
where it can be readily consulted and to consult
it whenever appropriate.
WARNING
Do not remove or deface the Attention, Warning
or Instruction decals. Replace any missing or
illegible decals. Missing or damaged decals
can be obtained at your nearest Corghi dealer.
- When using and carrying out maintenance on
the equipment, observe the standardised
industrial accident prevention regulations.
- Unauthorised alterations or changes to the
equipment relieve the constructor of all liabil-
ity for any consequent damage or accidents. In
particular, tampering with or removing safety
devices constitutes a breach of Safety at Work
Regulations.
WARNING
During work and maintenance operations, al-
ways tie up long hair and do not wear loose or
floppy clothing, ties, necklaces, wristwatches
or any other items that may get caught up in
the moving parts.
Operator's Manual EXACT 70 II
GENERAL
CHARACTERISTICS
- Angle readings with infrared CCD
- 0.01 degree data display
- Databank on hard disk
- User databank and jobs archive
- Guide to vehicle adjustment with stationary
or animated images
- SVGA colour monitor (resolution 800x600
pixels, 256 colours). LCD, 17" and 19"
- Colour INJKET or B/W LASER printer
- Professional alphanumeric keyboard
- Exceptional operating freedom, the user can
switch between adjustments at will
- Run-out compensation modes: once-round
ROC, push mode ROC
- Repetition of compensation on a single wheel
(single-wheel ROC)
- Steering angle measured automatically and
directly by the sensors; no need for electronic
turntables
- Steering angle measurement even for 4WS
cars
- Data displayed in degrees, grades, millimetres
and inches
- Graphic comparison between the data read
and the databank values
- Vehicle chassis diagnostics
- 10", 19" or 10"-26" self-centring clamp with
built-in spoiler adapter
- Remote control.
EN
53