Publicidad
Idiomas disponibles
Idiomas disponibles
DIESEL PARTICULATE FILTER REGENERATION WITH BUTTON-OPERATED DEVICE
Regeneration of the particulate filter must
be performed by pressing the dedicated
GB
button device. The cycle duration is
approximately 15 minutes (the actual time
depends on the amount of particulate
accumulated in the DPF) NOTES:
regeneration is activated with the engine in
operating temperature 70° C - 80° C (158°
F - 176° F), however not lower than 65° C
(149° F).
DANGER - WARNING
Before starting the stationary
regeneration process, ensure the safety
of the regeneration service personnel
and the personnel in the surrounding
area.
1) Keep engine at idle speed
2) Put transmission in neutral
3) Engage the vehicle parking brake
4) Press and hold the regeneration request
button for 3 (three) seconds and then
release it. The engine will increase to
approx. 2000 rpm. Let the engine run. The
DPF regeneration process is considered
complete when the engine spontaneously
returns to idle speed.
Let the engine run for approx. one minute
before turning it off.
English
IMPORTANT
In order to know the location of this
stationary regeneration button, refer
to the documentation provided by the
manufacturer of the vehicle in which the
engine is installed.
IMPORTANT
The engine noise may change during
the regeneration cycle and the engine
vibration may differ from normal opera-
ting conditions.
DANGER - WARNING
To avoid injury from inhaling engine
exhaust gases, always operate the
engine in a well-ventilated area. Engine
exhaust gases are toxic and deadly.
CAUTION - PRECAUTION
During the stationary regeneration
process, do not park the vehicle in
an area with flammable materials or
any other part that may burn by heat
radiation or in contact with the engine
exhaust system.
32
R756EU6EH
42432108F
Publicidad
