ENGINE ROUTINE MAINTENANCE
The routine maintenance operations,
necessary for the care of the engine, are
collected below in a specific table and
distinguished according to the operating
time and engine components:
- Routine maintenance table during
running-in (first 50 hours).
ROUTINE MAINTENANCE TABLE DURING RUNNING-IN (FIRST 50 HOURS)
Log each maintenance operation in the proper record sheet to pag. 49.
Frequency
Component
(1)*
Engine oil
Coolant
Every 10
hours
Air filter
Cooling system
applied to the engine
(radiator, intercooler,
fan)
After the
first 50
hours (at
Oil filter (2)*
the end of
running-in)
(1)* If an hour counter is not available, the
operation frequency is calculated on the basis of
the calendar day: one calendar day corresponds
to 12 hours of operation.
(2)* If the engine has not been in operation for
the specified time, the oil filter cartridge must be
replaced in any case at least every 12 months.
English
- Routine maintenance table after run-
ning-in (oil pan 300 hours).
- Routine maintenance table after run-
ning-in (oil pan 500 hours).
Type of Operation
Level check
Level check
Check - cleaning
pressure compressed
Clean the filter or, if
Check of clogging
necessary, replace it
indicator located on
with a new one. Reset
the filter body
the clogging indicator.
Check - cleaning
manufacturer of the
vehicle in which the
engine is installed
Replacement
(3)* Respect the instructions of the
manufacturer of the vehicle in which the engine
is installed.
43
R756EU6EH
Operation
Reference / Notes
Procedures
Topping up, if
See "Engine oil level
necessary
check" (page 54)
Topping up, if
coolant level check
necessary (3)*
and replacement"
Clean with low
See "Air filter cleaning
air
and replacement"
Respect the
instructions of the
-
GB
See "Engine
(page 63)
(page 53)
-
See "Engine oil
filter cartridge
replacement"
(page 57)
42432108F