Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Preparing the worktop
•
The worktop in which the glass ceramic hob is to be installed must be at least 30 mm thick.
The glass ceramic hob must lie horizontally and be sealed against the wall to prevent liquids
•
from overflowing.
The cut edges of the worktop must be sealed with special lacquer, silicone rubber or cast
•
resin to prevent swelling due to moisture.
The distance between the cut-out edges on the sides and the left-hand or right-hand wall
•
must be at least 50 mm.
The cut-out must be in the middle of the furniture base.
•
The kitchen furniture, including carrier material, surface coating, adhesives and sealing
•
materials must have adequate heat resistance of at least 100 °C in accordance with DIN
68930:2009-11
6
Accessory material for glass ceramic hob, see Figure C.
Further information can be obtained from the kitchen manufacturer
6
Page | 48
.
Publicidad
