Descargar Imprimir esta página

Dalbach HE03 Instrucciones De Uso Instrucciones De Montaje página 49

Conjunto de horno empotrable con encimera vitrocerámica

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 227
12.3 Installing the glass ceramic hob
Observe the following when installing the glass ceramic
hob.
Check the dimensions of the cut-out in the worktop again.
Keep the edges of the cut-out clean and free from grease.
Position the glass ceramic hob over the cut-out in the
worktop with the residual heat indicator facing forwards.
The front edge of the glass ceramic hob must run parallel to
the front edge of the worktop.
Slowly lower the glass ceramic hob into the cut-out until it
is lying flat on the worktop.
Press down the edge of the glass ceramic hob all round.
Secure the hob to the worktop from below with:
4 pcs. Retaining clamps
-
4 pcs. Fasten the screws.
-
Electrocution hazard!
Switch off or unscrew the fuse for the
cooker power circuit.
ATTENTION
Carefully place the glass ceramic hob into the
worktop. It must work the first time!
→ Otherwise the glass ceramic hob cannot
be easily lifted out again and the sealing
tape does not stick as well the second
time.
Fig. 7 Cross-section of installed
glass ceramic hob
A Glass ceramic hob
B Seal
C Worktop
D Screw
E Retaining clamp
EN
Page | 49

Publicidad

loading

Este manual también es adecuado para:

Kfh60-03