Publicidad
Brentwood Assembly Instructions
Fig. 25
(2) 2-1/2'' screws
U. 2 FOR FUN SWING.
1. Place Bolt Covers over the top of the swing hangers and loc nuts. Secure to the supports using 2-1/2'' screws
per Bolt Cover, as shown in (Fig. 25).
2. Thread chains through 2 for Fun handles as shown in (Fig. 25a).
3. Attach handle assembly to seat using (1) 6 1/2" hex head bolts, (1) 5/16" loc washer, (2) 5/16" washers,
and (1) 5/16" loc nut. Locate hardware as shown in (Fig. 25a). Repeat this for the other side.
NOTE: Do not overtighten bolts. The bolt threads should not extend beyond the end of loc nut.
Overtightening can damage the 2 For Fun Glider assembly and cause injury. Check this connection
frequently to see if the Loc Nut stays in position. If there is any problem keeping the loc nut in position.
Replace it immediatly.
4. Attach 2 for FUN Glider to set. Crimp all swing hangers and clamps tightly.
Bolt Cover
Chain goes
through here
5/16" Flat Washer
Hex Bolt
5/16 x 6-1/4"
5/16" Loc Washer
2 for FUN
Glider Seat
38
Fig. 25a
•WARNING•
Do NOT Put Chain Here
5/16" Flat
Washer
5/16''
Loc Nut
Publicidad
