Descargar Imprimir esta página

Briggs & Stratton SYT410 Manual Del Operario página 19

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 80
1. Put the rider on a smooth level surface. 
2. Attach the quick disconnect (A, Figure 17) to the garden
hose (B) and then connect to the washout port (C) on the
mower deck. 
3. Turn the water ON. 
4. Start the engine. 
5. Set the Height-of-Cut in the highest position. 
6. Engage the Power Take-Off (PTO) switch to activate the
mower blades. The rotation of the blades and the running
water will clean the underside of the mower deck. 
7. Disconnect the Power Take-Off and stop the engine. 
8. Turn the water OFF. 
9. Remove the garden hose and quick disconnect from the
washout port (C). 
Storage
WARNING
Never store the unit (with fuel) in an enclosed, non-
ventilated structure. Fuel vapors can travel to an ignition
source (such as a furnace, water heater, etc.) and cause an
explosion. 
• Store away from furnaces, stoves, water heaters, or
other appliances that have pilot lights or other ignition
sources because they can ignite fuel vapors. 
Equipment 
Turn OFF the Power Take-Off (PTO), and set the parking
brake. Remove the starter insert. Let the machine cool.
If you remove the battery, the battery life will increase. Make
sure that the battery is in a cool, and dry location, and keep
it fully charged. If the battery is left in the unit, disconnect the
negative cable. 
Fuel System 
Fuel can become stale when kept in a storage container
for more than 30 days. Each time you fill the container
with fuel, add fuel stabilizer to the fuel as specified by the
manufacturer's instructions. This keeps fuel fresh and
decreases fuel-related problems or contamination in the fuel
system.
It is not necessary to drain fuel from the engine when fuel
stabilizer is added as instructed. Before storage, turn the
engine ON for 2 minutes to move the fuel and stabilizer
through the fuel system.
Before starting the machine after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Do all recommended checks and procedures found in this
manual. 
• Make sure the engine is warm before you use it. 
19

Publicidad

loading