Husqvarna BMR 25P Manual Del Usuario página 15

2. Pull the bottom part of the movement control up.
3. Move the movement control lever to adjust the
speed.
a) To increase the speed for forward operation,
push the movement control lever.
b) To decrease the speed for forward operation, pull
the movement control lever in direction of the
neutral position.
c) To increase the speed for rearward operation,
pull the movement control lever.
d) To decrease the speed for rearward operation,
push the movement control lever in direction of
the neutral position.
To start the product
1. Turn the pinch bar 1 step. Refer to
bar on page 17 .
2. Open the valve of the propane tank.
3. Sit on the seat.
4. Make sure that the emergency stop button is
disengaged.
5. Make sure that the movement control lever is in the
neutral position.
6. Turn the ignition key to START position.
2272 - 001 - 14.05.2024
7. Set the engine speed to 3600 rpm with the engine
To operate the product
1. Make sure that the work area is safe. Refer to
2. Fill the separator with abrasive material. Refer to
To turn the pinch
3. Open the dust valve. Refer to
4. Start the product. Refer to
5. Push the "Freeflow" button to lower the shot blaster
6. Push the button to engage the clutch (B) to start the
7. Push the movement control lever (C) forward from
RPM control. The engine speed (ft/min) is shown
on the speed level indicator. Refer to
overview on page 4 .
WARNING:
shot blaster head during operation. Abrasive
material comes out of the product at high
speed and can cause injury.
area safety on page 8 .
fill the product with abrasive material on page 13 .
valve on page 14 .
page 15 .
head (A). The shot blaster head is on the ground
after approximately 5 seconds.
A
E
blast wheel and the dust collector.
neutral position to move the product forward.
CAUTION:
operate rearward.
Control panel
Do not lift the cover of the
Work
To operate the dust
To start the product on
B
C
D
F G
The product does not
To
15