Husqvarna BMR 25P Manual Del Usuario página 23

3. Remove the 6 nuts, 12 washers and the cover of the
filter housing.
4. Remove the wing-nut at the bottom of the primary
filter.
5. Pull out the primary filter and put it carefully in a
plastic bag.
WARNING:
remove the primary filters. The particles
in the primary filters are dangerous to
your health.
6. Discard the plastic bag correctly. Refer to local
regulations.
7. Install the new primary filters in opposite sequence.
WARNING:
not installed correctly, dust can come
in to the air. The dust particles are
dangerous to your health.
8. Do the same replacement procedure on the other 5
primary filters.
9. Install the cover of the filter housing, the 12 washers
and the 6 nuts.
2272 - 001 - 14.05.2024
Be careful when you
If the primary filters are
To replace the HEPA filter
WARNING:
The HEPA filter will break if you clean it.
WARNING:
the new HEPA filter. Do not touch the inner
surface of the HEPA filter, it will break by all
types of force or damage.
WARNING:
protective equipment when you change the
HEPA filter. Refer to
equipment on page 7
1. Remove the 4 screws, 4 nuts and the cover of the
HEPA filter compartment (A).
2. Remove the HEPA filter (B) from the product and put
it carefully in a plastic bag.
WARNING:
to local regulations.
3. Install a new HEPA filter in the opposite sequence.
To fill the propane tank
CAUTION:
and lines each time the propane tank is filled
and/or connected to the product. Refer to
examine the propane tank and lines on page
24 .
Do not fill the propane tank too much. The propane tank
can hold a maximum of 9 kg/20 lbs of propane. A full
Do not clean a HEPA filter.
Be careful when you install
Use correct personal
Personal protective
B
A
Dispose the bag, refer
Examine the propane tank
To
23