Publicidad
Idiomas disponibles
Idiomas disponibles
propane tank must not weigh more than 21.8 kg/48 lbs.
If the propane tank is filled too much, frost shows on the
propane lines or on the regulator.
1. Stop the product. Refer to
page 16 .
2. Make sure that the propane tank valve is closed.
3. Remove the propane tank from the product.
4. Fill the propane tank with new propane or replace
the propane tank.
5. Install the filled/new propane tank to the product.
To connect and disconnect the propane
Refer to
tank on page 14 .
6. If the weather is cold, keep the product indoors
before use to warm up the propane tank. You can
also use a propane tank heat blanket to warm up the
propane tank.
To examine the propane tank and lines
CAUTION:
and lines each time the propane tank is filled
and/or connected to the product.
1. Make sure that the propane tank has no damages.
2. Connect the propane tank to the product. Refer to
connect and disconnect the propane tank on page
14 .
3. Apply a soap mixture as a spray at all lines and
connections. For soap mixture use 50% soap and
50% water.
4. If there are bubbles, there is a leakage. Do not
start the engine if there is a leakage. Speak to an
approved service agent.
To clean the engine and the muffler
CAUTION:
manual of the engine before you do
maintenance in the product.
•
Let the engine and the muffler become cool before
you clean them.
•
Clean the engine and the muffler with a cloth.
•
Make sure that the cold air intake grille is not
blocked. Remove dirt with a soft brush.
To do a check of the engine oil level
CAUTION:
manual of the engine before you do
maintenance to the product.
1. Park the product on a level surface and stop the
engine.
24
To stop the product on
Examine the propane tank
Always read the service
Always read the service
2. Remove the dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to the engine
To
manual.
To examine the spark plug
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
•
Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
•
To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel type is correct.
c) Make sure that the air filter is clean.
•
If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 31 .
•
Replace the spark plug if it is necessary.
Always use the
Technical data
2272 - 001 - 14.05.2024
Publicidad
