Husqvarna BMR 25P Manual Del Usuario página 16

a) Do a check of the speed on the speed level
indicator (D).
8. Use the steering wheel (E) to control the front wheel
and the direction of the product.
9. Push the button to open the valve for the abrasive
material (F).
CAUTION:
before you open the valve for the
abrasive material.
10. After 5 m/16 ft., close the valve for the abrasive
material (G).
11. Stop the product. Refer to
page 16 .
12. Close the propane tank valve.
13. Do a check of the blasted surface. Set the correct
To select the correct speed on page
speed. Refer to
14 .
Blast pattern
The blast pattern (A) is the surface that has received
treatment.
A
These are the conditions that have effect on the blast
pattern:
• Operation speed.
• Increased wear on the blast wheel and pinch bar.
• The dimension of the abrasive material.
• Different types and hardness of the surface.
To stop the product
1. Push the button to close the valve for the abrasive
Control panel overview on page 4 .
material. Refer
CAUTION:
for the abrasive material is fully closed
before you stop the product.
16
The product must move
To stop the product on
Make sure that the valve
2. Operate the product continuously for 10 seconds to
make sure that there is no material in the system.
3. Set the movement control lever to the neutral
position.
4. Push the button to disengage the clutch.
5. Set 1300 RPMs with the engine RPM control.
6. Push the button to lift the shot blaster head.
7. Turn the ignition key to OFF.
8. Remove the ignition key from the product.
To discard a full BigBag and install a
new BigBag bag
WARNING:
caution, a full BigBag can be heavy. Make
sure that the cable ties are closed correctly
before you lift the BigBag.
WARNING:
protection when you empty the dust
collector. Refer to
equipment on page 7 .
1. Stop the product. Refer to
page 16 .
2. Close the dust valve. Refer to
valve on page 14 .
3. Remove the funnel of the BigBag from the dust
outlet and close it.
4. Pull the BigBag off the support rods.
5. Obey local regulations for disposal of the full BigBag
bag.
6. Install the funnel of the BigBag (A) on the dust outlet
(B).
B
C
A
Lift the BigBag with
Use approved respiratory
Personal protective
To stop the product on
To operate the dust
2272 - 001 - 14.05.2024