Husqvarna BMR 25P Manual Del Usuario página 26

2. Put a container below the hydraulic oil drain plug.
3. Remove the hydraulic oil drain plug.
4. Let the hydraulic oil drain into the container.
5. Clean around the hydraulic oil drain plug.
6. Remove the hydraulic oil cap.
7. Install the hydraulic oil drain plug when the hydraulic
oil tank is empty.
8. Fill the hydraulic oil tank until the hydraulic oil level is
at the center of the indicator. Refer to
of the hydraulic oil level on page 25 .
9. Install the hydraulic oil cap.
10. Operate the product for a short time to bleed the
system.
26
11. Do a check of the hydraulic oil level.
To replace the hydraulic oil filter
1. Drain the hydraulic system. Refer to
hydraulic oil on page 25 .
2. Remove the cover of the hydraulic oil filter.
3. Turn the hydraulic oil filter counterclockwise to
remove it.
4. Lightly lubricate the rubber seal on the new hydraulic
oil filter with new hydraulic oil.
5. Attach the hydraulic oil filter. Tighten by hand until
there is a resistance, then tighten an additional 3/4
turn.
6. Do a check that there are no leaks around the
hydraulic oil filter.
7. Fill the hydraulic oil tank. Refer to
hydraulic oil on page 25 .
To do a check
8. Do a check of the hydraulic oil level. Refer to
check of the hydraulic oil level on page 25 .
To replace the
To replace the
To do a
2272 - 001 - 14.05.2024