Husqvarna BMR 25P Manual Del Usuario página 18

Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 7 .
WARNING:
maintenance, stop the engine. Remove the
General product maintenance
Empty the dust collector.
Do a check of the of the sepa-
rator and the separator tray.
Lubricate the blast wheel bear-
ings. Make sure that the bear-
ings rotate during lubrication.
To lubricate the prod-
Refer to
uct on page 19 .
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Examine the engine for dirt and
damage.
Make sure that the dust collec-
tor hose is not damaged and
that there is no blockage.
Make sure that nuts and screws
are tight.
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush list
seals and rubber seals around
the shot blaster head for wear.
Do a check of the blast wheel,
blast wheel blades, pinch bar
and liners for wear.
18
Maintenance
Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
X
X
ignition key to prevent an accidental start.
Let the product become cool.
For all servicing and repair work on the product,
special training is necessary. Husqvarna guarantees
professional repair and servicing near you. If your dealer
is not a service agent, speak to them for information
about the nearest service agent.
For more information, refer to .
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Daily Each 600 h
X
*
*
*
*
X
X
X
X
Monthly Yearly
2272 - 001 - 14.05.2024