Attaching The Touch Pc Mounting Plate To The Cart Post - Boston Scientific LithoVue Manual Del Usuario

4. Assemble the (1) 5/16" hex head cap screw, (1) 5/16" flat washer and (1) 5/16" split lock washer
as shown in Figure 3�2 Start the screw by hand before using the 1/2" (13 mm) wrench to fully
tighten the screw. Tighten the screw until fully seated and the post no longer rotates.
Figure 3�2 – Attaching the cart Post to the cart Base
5. Return the Cart to the upright position and confirm that the three caster locks are pressed down
to lock the Cart into position.

Attaching the touch Pc Mounting Plate to the cart Post

The three-hole pattern on the top of the Cart Post is designed to orient the Touch PC Mounting Plate in one
direction only. The Touch PC Mounting Plate is designed to always position the Touch PC opposite the Cart's
Height Adjustment Knob. Secure the Touch PC Mounting Plate to the Cart Post as follows:
1. Place the Touch PC Mounting Plate on the Cart Post, aligning the three-hole pattern.
2. Insert the (3) flat-head Phillips Mounting Screws into the Touch PC Mounting Plate and Cart Post.
Start the screws by hand before tightening with the Phillips-head screwdriver. Tighten the screws
until they are snug and fully seated. See Figure 3�3.
3. Optional – if desired, cover the top of the mount with the included adhesive Lexan cover.
User's Manual
Cart Post
Cart Base
5/16" flat washer, 5/16" split lock
washer, and hex head cap screw
13
Black (K) ∆E ≤5.0