Assembly; Details - Ecolab Versatronic Instrucciones De Servicio

6

Assembly

Personnel:
6.1

Details

DANGER!
Under no circumstances may the device be mounted or dismounted under
voltage! There is a risk of electric shock.
Disconnect the entire system from the power supply beforehand.
This work may only be carried out by qualified personnel!
Under no circumstances may the device be mounted in hazardous areas!
There is a danger of explosion.
Installation site
When determining the installation site, care must be taken to ensure that the
specifications of the device are adhered to. The relevant tables with information on
enclosure specifications can be found in the section entitled "Technical Data"
Ä Chapter 13.16 'Housing' on page 251). The device must not be exposed to strong
(see
shocks and permanent vibrations. Electromagnetic fields, e.g. caused by motors or
transformers, must be avoided!
Direct heat radiation, especially solar radiation, leads to heating of the device inside the
housing due to the protection class IP67 and can damage the device. Make sure that the
device is not exposed to direct sunlight on site.
Climate conditions
The ambient temperature and relative humidity at the installation site must correspond to
the technical data. See also
Mounting position
Any mounting position is possible. However, the viewing angle of the TFT touchscreen
should be taken into account.
Space requirement
Make sure there is sufficient space around the cable entries.
The minimum bending radius of the cables must be taken into account!
n Mechanic
n Qualified electrician
n Service personnel
Ä Chapter 13.16 'Housing' on page 251.
43
Assembly
417102269 Rev. 2-08.2020