Ecolab Versatronic Instrucciones De Servicio página 512

PC setup program
Analogue outputs
Here, the analogue outputs of the device can be tested for function. For the selected
output and the set signal type a desired output value can be specified in the "set point".
The test run is started by pressing the "Test" button. During the test run, a window to
control the output signal is displayed. Here, you can enter the actual output value to check
the output value that you may have collected using a measuring device.
With the "Stop" button, the test run is stopped.
Go to: Online parameters è Configure / test (double-click) è Analogue outputs tab
Fig. 142: Analogue outputs
(1) "Stop" button stops a test run
(2) Dialogue box for measurement control during the test
run
(3) "Test" button starts a test run
(4) Setpoint
417102269 Rev. 2-08.2020
desired output value during the test run
(5) Selection of the signal type that is to be tested
(6) Selection of the analogue output that is to be tested
240