Calibration Of The Relative Cell Constants - Ecolab Versatronic Instrucciones De Servicio

Device menu

10.2.5.2 Calibration of the relative cell constants

Relative cell constant
The deviation from the nominal cell constant of a Ci-sensor is described by the relative
cell constant. By looping a resistor into the bore of the probe, a corresponding conductivity
value is simulated.
Fig. 66: To change the reference conductivity, push the button (Pos. 1)
1. Start the calibration of the relative cell constant.
Device menu Calibration Ci-analysis input or universal input Relative cell constant
calibration
2. When using calibration adapter 255269:
Kabel des Kalibrieradapters zweimal durch die Bohrung der Messsonde schleifen
Ä Chapter 10.2.5.5 'Basic Ci setup' on page 129, Fig. 71) und Schleife
(siehe
schliessen .
If necessary, adjust the value for the reference conductivity (see ,Fig. 66 Item 1) to
the simulation value of the selected resistance.
Enclosed the corresponding allocation table for calibration adapter 255269:
Resistance value
20 kΩ
2 kΩ
200 Ω
20 Ω
10 Ω
25 kΩ
2.5 kΩ
250 Ω
25 Ω
12,5Ω
When using simulation resistor 255198 (only with Versatonic cooling water): loop the
cable of the simulation resistor once through the bore of the measuring probe and
close the loop.
Die Referenzleitfähigkeit auf 5000 uS/cm einstellen (siehe Fig. 66, Pos. 1).
Wait for a stable measured value display, and confirm the measurement result with
'OK'
3. A summary log of the determined calibration values is then made. Acknowledge the
log with "OK".
Failed calibrations will be cancelled at this point and discarded.
4. By selecting "Yes", you assume the determined calibration values and the calibration
will be registered in the calibration log.
By Selecting "No", you wish to discard them.
417102269 Rev. 2-08.2020
simulated conductivity value
1.38 mS/cm
13.8 mS/cm
138 mS/cm
1380 mS/cm
2760 mS/cm
1.10 mS/cm
11.04 mS/cm
110.4 mS/cm
1104 mS/cm
2208 mS/cm
126