Displaying Setpoints And Actual Values - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

6 System Monitoring
Position Display group
B Live values
C Change control
mode
6.9.2

Displaying Setpoints and Actual Values

1. To do this you must be logged in as Installer: Go to the menu Plant Overview via the page and menu selection.
2. Choose Operations > Mode via the page and menu selection (see Section 6.9.1 "Overview of Operating
Modes and Setpoints", page 41).
42 FSC20-BA-xx-20
Parameters / Description
Functions
Calculated sys- Calculated active power requirement of the loads in kW
tem load
Running genset Sum of nominal power of all active gensets in kW
capacity
PV production Active power of the PV power plant in kW
Genset power Active power of the gensets in kW
production
Available spin- Current reserve power of the gensets in kW
ning reserve
Battery active Active power of the storage system in kW
power
Current opera- Shows the current operating mode of the SMA Fuel Save Con-
tion troller:
• Automatic mode (see Activate automatic mode)
The Fuel Save Controller normally operates in Automatic
mode.
– The SMA Fuel Save Controller calculates the setpoints
– It is possible to have the setpoints for the PV power
• Manual mode (see Activate manual mode)
Manual mode is normally used only when the SMA Fuel
Save Controller is being commissioned. In Manual mode,
the reserve power to be kept by the gensets is specified
via the user interface.
• SLOW STOP mode
The Fuel Save Controller stops the PV inverter (see
Section 10.1, page 99).
Activate auto- Activate Automatic mode (see Section 6.9.3, page 43)
matic mode
Activate man-
Activate Manual mode (see Section 6.9.3, page 43)
ual mode
Enable SCADA Activate setpoint specification by a SCADA system (see Sec-
to send set- tion 6.9.4, page 43)
points
SMA Solar Technology AG
for the PV power plant and the reserve power to be
retained by the gensets.
plant specified by a SCADA system.
User Manual