Parameters For Gensets With Genset Controller Comap Ig-/Is-Ntc - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

7 System Settings
Parameter Description
ESENET-Gate- ID address of the genset con-
way IP Address troller (not applicable with a
higher-level control system)
Unit ID (Mod- Genset controller ID for the Mod-
bus/TCP) bus/TCP protocol
7.2.4

Parameters for Gensets with Genset Controller ComAp IG-/IS-NTC

Genset general configuration
Parameter Description
Remaining Remaining number of config-
available de- urable gensets
vices
Number of de- Number of installed gensets
vices
Genset inter- Type of genset interface*
face Type
ComAp access Password for access to the genset
code controller
ComAp admin Administrator password for write
password access to parameters of the
genset controller
Genset setpoint Activates the writing of reserve
mechanism power setpoints to the genset
controller system (see Sec-
tion 8.1.1, page 70).
* The display of the following parameters changes according to the setting of the parameter Genset interface Type.
Generator configuration wizard: detailed configuration
Parameter Description
Label Genset / genset controller ID
48 FSC20-BA-xx-20
Value Explanation
172.16.1.31 to Address range defined by
172.16.1.38 the Fuel Save Controller for
gensets
1 to 254 –
Value Explanation
– –
0 to 8 –
ComAp IG-/IS-NTC Genset controller "ComAp
IG-NTC / ComAp IS-NTC"
with Modbus/TCP commu-
nication
0 to 65535 The maximum length of the
password is 16 bits.
0 to 65535 The maximum length of the
password is 16 bits.
Checkbox activated The specification of set-
points for the reserve
power is activated.
Checkbox deacti- The specification of set-
vated points for the reserve
power is deactivated.
Value Explanation
– –
SMA Solar Technology AG
Default
value
172.16.1
.31
–
Default
value
–
0
None
0
0
Deacti-
vated
Default
value
–
User Manual