SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso página 60

7 System Settings
Parameter Description
Alias Name for identification of
measurement devices
Enable this device Determines whether the
Fuel Save Controller should
take the measurement de-
vice into account in the con-
trol of the PV diesel hybrid
system
IP address IP address of the Data Ac-
quisition Module
Data source priority Use of the measured values
from the Fuel Save Con-
troller in the event of a com-
munication connection fail-
ure
Assign measurement Overview of the activated
points devices, e.g. PV inverters
Requirement:
☐ You must be logged in as Installer.
☐ You must have performed all necessary settings in the area External measurement devices in the menu
Measurement devices general configurations 55.
60 FSC20-BA-xx-20
Value Explanation
– –
Yes The Fuel Save Controller
takes the measurement de-
vice into account.
No The Fuel Save Controller
does not take the measure-
ment device into account.
172.16.0.0 to The IP address of the
172.17.255.2 Data Acquisition Module is
55 defined during commission-
ing.
Single source Connection to the device
carrying out the measure-
ments is disabled. Only the
measured values from the
Fuel Save Controller are
used.
Second source Connection to the device
carrying out the measure-
ments is enabled. The val-
ues communicated by the
device have priority. If com-
munication fails, the mea-
sured values from the
Fuel Save Controller are
used.
Measurement Connection to the device
priority carrying out the measure-
ments is enabled. The val-
ues measured by the
Fuel Save Controller have
priority. In case of measure-
ment failure, the values
communicated by the de-
vice are used.
Via the button [Show devices], a menu is called up in which
devices can be activated or deactivated for the selected mea-
surement device. Furthermore, the devices that are connected
to the digital inputs of the Data Acquisition Module are config-
ured via this menu.
SMA Solar Technology AG
Default value
–
No
–
–
User Manual